equipment:vinyl_cutter_how_to
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
| equipment:vinyl_cutter_how_to [2015/02/25 15:46] – [Finishing Up] Karen Corbeill | equipment:vinyl_cutter_how_to [2019/11/01 15:21] – Jen Doser | ||
|---|---|---|---|
| Line 3: | Line 3: | ||
| Software: Sure Cuts A Lot 3 Pro | Software: Sure Cuts A Lot 3 Pro | ||
| - | Your design must be a vector to be able to cut it. Rasters do not work. | + | Your design must be a [[https:// |
| You may draw a design using the tools in SCAL, or import a picture to create your own design. Complex pictures will be very difficult to turn into designs. Clean lines, work best. | You may draw a design using the tools in SCAL, or import a picture to create your own design. Complex pictures will be very difficult to turn into designs. Clean lines, work best. | ||
| Line 40: | Line 40: | ||
| Confirm that the **Speed** is set to **300 mm/s** and the **Pressure** to **040g**. | Confirm that the **Speed** is set to **300 mm/s** and the **Pressure** to **040g**. | ||
| + | |||
| + | *Note: If cutting HTV (Heat Transfer Vinyl), extend the blade out a bit, and use 200g pressure and 120 mm/s speed. Remember to change back to default settings and **retract the blade** back when you're done. | ||
| ===== Preparing and Cutting your File in Sure Cuts A Lot: ===== | ===== Preparing and Cutting your File in Sure Cuts A Lot: ===== | ||
equipment/vinyl_cutter_how_to.txt · Last modified: 2022/05/29 16:01 by 127.0.0.1