The Bodgery Wiki

User Tools

Site Tools

Trace:
homebrew_cnc

Differences

This shows you the differences between two versions of the page.

Link to this comparison view

Both sides previous revisionPrevious revision
Next revision		Previous revision
Last revisionBoth sides next revision
homebrew_cnc [2016/05/23 17:43] – tanzseglerhomebrew_cnc [2016/06/01 18:19] – [Cost To Use] tanzsegler
Line 13: Line 13:
  
 ===== Cost To Use ===== ===== Cost To Use =====
-  * $5/hr+  * $5/hr runtime
 ===== Specs ===== ===== Specs =====
  
Line 58: Line 58:
 ===== History ===== ===== History =====
  
 +day/month/year\\
 17/04/2016 Started a timeline\\ 17/04/2016 Started a timeline\\
 2015       Acquired Homebrew CNC from Milwaukee Makerspace\\ 2015       Acquired Homebrew CNC from Milwaukee Makerspace\\
Line 63: Line 64:
 20/02/2016 CNC router operational. \\ 20/02/2016 CNC router operational. \\
 25/03/2016 X axis stepper motor overheating.\\ 25/03/2016 X axis stepper motor overheating.\\
-17/04/2016 Purchased 3NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\+17/04/2016 Purchased 3 NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B) TY James Pittman!\\
 17/04/2016 Replaced X,Y steppers with NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\ 17/04/2016 Replaced X,Y steppers with NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\
-23/04/2016 Switched X,Y steppers from parallel to series. Power draw was to high in parallel.\\+23/04/2016 Switched X,Y steppers from parallel to series. Power draw was too high in parallel.\\
homebrew_cnc.txt · Last modified: 2022/05/29 16:01 by 127.0.0.1