homebrew_cnc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revisionLast revisionBoth sides next revision | ||
homebrew_cnc [2016/05/23 18:09] – [History] tanzsegler | homebrew_cnc [2016/06/01 18:19] – [Cost To Use] tanzsegler | ||
---|---|---|---|
Line 13: | Line 13: | ||
===== Cost To Use ===== | ===== Cost To Use ===== | ||
- | * $5/hr | + | * $5/hr runtime |
===== Specs ===== | ===== Specs ===== | ||
Line 64: | Line 64: | ||
20/02/2016 CNC router operational. \\ | 20/02/2016 CNC router operational. \\ | ||
25/03/2016 X axis stepper motor overheating.\\ | 25/03/2016 X axis stepper motor overheating.\\ | ||
- | 17/04/2016 Purchased | + | 17/04/2016 Purchased |
17/04/2016 Replaced X,Y steppers with NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\ | 17/04/2016 Replaced X,Y steppers with NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\ | ||
23/04/2016 Switched X,Y steppers from parallel to series. Power draw was too high in parallel.\\ | 23/04/2016 Switched X,Y steppers from parallel to series. Power draw was too high in parallel.\\ |
homebrew_cnc.txt · Last modified: 2022/05/29 16:01 by 127.0.0.1