Differences

This shows you the differences between two versions of the page.

--- equipment:laser_cutter_150w [2021/04/23 04:10] – [Tips and Tricks] Adding James's wisdom from slack vbasile
+++ equipment:laser_cutter_150w [2023/03/06 03:26] (current) – [Notes] jamesp
@@ Line 16: / Line 16: @@
 {{ :equipment:laser_cutter:lasercutterorientation.pdf |Laser Cutter Handout}}
-[[equipment:laser_cutter_50w_tutorial|Settings and tutorial]] on using it.
 [[https://www.youtube.com/playlist?list=PLeKaKWOIPgi_XP6Nxzeapp-vUMCLQyVMB|Informative video series by Russ of Sabar Multimedia]]
+[[https://drive.google.com/open?id=1VYQCxWqMdUxkUEqs9pJGCVKcTS2RcB7l|RDWorks 8.01.26]]
+[[equipment:laser_cutter_50w_tutorial|Settings and tutorial]] on using it.
  ===== Specs =====
@@ Line 42: / Line 42: @@
   * The kerf will also be variable from the top to the bottom of the laser-cut piece, being wider on the top and thinner near the bottom. The variation will be more pronounced in thicker materials.
   * Always test settings on your material before cutting your whole piece.
+  * **It's best to cut in the top-left part of the bed.**  The power is strongest in the top-left corner and gets weaker as you move down or right.  The difference from the top-left corner to the bottom-right corner has been measured as a 10% power loss.
-**It's best to cut in the top-left part of the bed.**  The power is strongest in the top-left corner and gets weaker as you move down or right.  The difference from the top-left corner to the bottom-right corner has been measured as a 10% power loss.
+  * **Plywood that's extra-charred?** If the inner layers of the plywood have a knothole or a gap, glue can squeeze into that void and create an inclusion. The laser does not cut through glue well at all, so it fails to cut that spot. It also tends to create much darker soot. Running a bit slower might give you a buffer and allow you to cut all the way through it. A higher grade of plywood might help but its debatable.  Unfortunately, its just a downside to using plywood.
-**Plywood that's extra-charred?** If the inner layers of the plywood have a knothole or a gap, glue can squeeze into that void and create an inclusion. The laser does not cut through glue well at all, so it fails to cut that spot. It also tends to create much darker soot. Running a bit slower might give you a buffer and allow you to cut all the way through it. A higher grade of plywood might help but its debatable.  Unfortunately, its just a downside to using plywood.
 ===== Materials Information =====
@@ Line 69: / Line 67: @@
 Coming Soon...
+===== Teamup Calendar =====
+All shop Teamup scheduling calendars are accessible from:
+  * The heading area of the shop area's Slack channel
+  * The [[https://mms.thebodgery.org/account/|Membership Account Page]]