Differences

This shows you the differences between two versions of the page.

--- equipment:vinyl_cutter [2014/08/16 03:05] – John Eich
+++ equipment:vinyl_cutter [2017/10/07 01:44] – Karen Corbeill
@@ Line 2: / Line 2: @@
 ~~NOTOC~~
 {{ :equipment:us-cutter-mh871.jpg?400|}}
  ===== Make/Model =====
@@ Line 10: / Line 11: @@
   * Maximum Cut Width:  30.63"
   * Maximum Cut Length:  8 feet
-  * What it can cut:  Standard Vinyl, Heat Transfer Vinyl, Paper, Craft Paper, Card Stock, Paint Mask
+  * What it can cut:  Standard Vinyl, Heat Transfer Vinyl, Paint Mask
-  * What it cannot cut:  Tint, Laminate, Sand Blast Resist, Low-Intensity Reflective, High-Intensity Reflective, Un-backed or un-linered media without the use of a carrier sheet
   * Blade Types:  Standard blade compatible
   * Command sets:  DM-PL HP/GL automatic identification
   * Motor Type:  Stepper
   * Speed:  39 in/s
-  * Force:  350g
+  * Max Force:  350g
   * Included Software:  Sure Cuts A Lot Pro
+  * Preferred file format: .svg
   * Included Accessories:  USB Cable, Power Cable, Blade Holder, Pen Holder, 3x 45° Blade
+  *Current vinyl in stock: 4mm adhesive vinyl
+     *12" rolls: green, yellow, white, black, blue, green, orange, pink, silver, gold, lime green, burgundy
+=== Accessories Available ===
+  * Picks, squeegees, hobby knives, cutting mat
+  * Vinyl stock, Transfer tape
+====Recommended Settings====
+Pressure: 40g
+Speed: 300mm/s
@@ Line 27: / Line 40: @@
  ===== Location =====
-Currently: Craft/Electronics area upstairs in the loft.
+Currently: Fab Lab. Shop.
@@ Line 35: / Line 48: @@
  ===== History =====
 /15/14 - Arrived at Makerspace\\
-/??/14 - Online
+/26/14 - Online
 ===== Notes =====
+**[[Vinyl_Cutter_How_To|How To Use the Vinyl Cutter]]**
@@ Line 45: / Line 58: @@
 [[http://www.uscuttersupport.com/downloads/Vinyl_Cutters/Refine/MH_Series/mh_mk1_manual.pdf|Manual Online]]