howto_connect_the_doorbot
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revision | Last revisionBoth sides next revision | ||
| howto_connect_the_doorbot [2024/04/05 19:13] – [Things You Need] Timm Murray | howto_connect_the_doorbot [2024/04/05 19:13] – [Things You Need] Timm Murray | ||
|---|---|---|---|
| Line 6: | Line 6: | ||
| * The hat for the esp32 | * The hat for the esp32 | ||
| * 3d printed case for the above | * 3d printed case for the above | ||
| - | * A 7 pin female 2.54mm header (like these: https:// | + | * A 7 pin female 2.54mm header (like these: https:// |
| - | ** Can take a long header and cut it to size with a wire cutter | + | |
| * 12V power supply (can also be 24V if the electric strike needs that) | * 12V power supply (can also be 24V if the electric strike needs that) | ||
| * Power plug with a pigtail compatible with that power supply | * Power plug with a pigtail compatible with that power supply | ||
howto_connect_the_doorbot.txt · Last modified: 2024/04/12 16:53 by Mark Pickard