equipment:vinyl_cutter_how_to
Differences
This shows you the differences between two versions of the page.
| Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
| equipment:vinyl_cutter_how_to [2017/04/06 04:18] – [Vinyl Cutter How To] included link to explanation of vectors vs rasters Andrea Crain | equipment:vinyl_cutter_how_to [2022/05/29 16:01] (current) – external edit 127.0.0.1 | ||
|---|---|---|---|
| Line 40: | Line 40: | ||
| Confirm that the **Speed** is set to **300 mm/s** and the **Pressure** to **040g**. | Confirm that the **Speed** is set to **300 mm/s** and the **Pressure** to **040g**. | ||
| + | |||
| + | *Note: If cutting HTV (Heat Transfer Vinyl), extend the blade out a bit, and use 200g pressure and 120 mm/s speed. Remember to change back to default settings and **retract the blade** back when you're done. | ||
| ===== Preparing and Cutting your File in Sure Cuts A Lot: ===== | ===== Preparing and Cutting your File in Sure Cuts A Lot: ===== | ||
equipment/vinyl_cutter_how_to.1491452322.txt.gz · Last modified: 2022/05/29 16:01 (external edit)