homebrew_cnc
Differences
This shows you the differences between two versions of the page.
Both sides previous revisionPrevious revisionNext revision | Previous revision | ||
homebrew_cnc [2016/05/23 17:43] – tanzsegler | homebrew_cnc [2022/05/29 16:01] (current) – external edit 127.0.0.1 | ||
---|---|---|---|
Line 13: | Line 13: | ||
===== Cost To Use ===== | ===== Cost To Use ===== | ||
- | * $5/hr | + | * $5/hr runtime |
===== Specs ===== | ===== Specs ===== | ||
Line 58: | Line 58: | ||
===== History ===== | ===== History ===== | ||
+ | day/ | ||
17/04/2016 Started a timeline\\ | 17/04/2016 Started a timeline\\ | ||
2015 | 2015 | ||
Line 63: | Line 64: | ||
20/02/2016 CNC router operational. \\ | 20/02/2016 CNC router operational. \\ | ||
25/03/2016 X axis stepper motor overheating.\\ | 25/03/2016 X axis stepper motor overheating.\\ | ||
- | 17/04/2016 Purchased | + | 17/04/2016 Purchased |
17/04/2016 Replaced X,Y steppers with NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\ | 17/04/2016 Replaced X,Y steppers with NEMA23 425oz/in 2.8A Stepper Motor ¼” Dual shaft (KL23H286-20-8B)\\ | ||
- | 23/04/2016 Switched X,Y steppers from parallel to series. Power draw was to high in parallel.\\ | + | 23/04/2016 Switched X,Y steppers from parallel to series. Power draw was too high in parallel.\\ |
homebrew_cnc.1464025433.txt.gz · Last modified: 2022/05/29 16:01 (external edit)